Kramer VS-211XS - Page 82

Kramer Electronics Ltd.
VS-211XS, VS-411XS – Protocol 3000
80
Function
Description
Syntax
Parameters/Attributes
Example
TIME-SRV
Set time server.
This command is
needed for setting
UDP timeout for the
current client list.
COMMAND
#TIME-SRVmode,time_server_ip,sync_hour<CR>
FEEDBACK
~nn@TIME-SRVmode,time_server_ip,sync_hour,server_status<
CR><LF>
mode – On/Off
0 – Off
1 – On
time_server_ip – Time server IP
address
sync_hour – Hour in day for time server
sync
server_status – On/Off
Set time server with
IP address of
128.138.140.44 to
ON:
#TIME-
SRV1,128.138.14
0.44,0,1<CR>
TIME-SRV?
Get time server.
This command is
needed for setting
UDP timeout for the
current client list.
COMMAND
#TIME-SRV?<CR>
FEEDBACK
~nn@TIME-SRVmode,time_server_ip,sync_hour,server_status<
CR><LF>
mode – On/Off
0 – Off
1 – On
time_server_ip – Time server IP
address
sync_hour – Hour in day for time server
sync
server_status – On/Off
Get time server:
#TIME-SRV?<CR>
VERSION?
Get firmware version
number.
COMMAND
#VERSION?<CR>
FEEDBACK
~nn@VERSIONfirmware_version<CR><LF>
firmware_version – XX.XX.XXXX
where the digit groups are:
major.minor.build version
Get the device
firmware version
number:
#VERSION?<CR>
VMUTE
Set enable/disable
video on output.
Video mute
parameter 2 (blank
picture) is not
supported.
COMMAND
#VMUTEout_index,flag<CR>
FEEDBACK
~nn@VMUTEout_index,flag<CR><LF>
out_index – Number that indicates the
specific output:
1-N (N= the total number of outputs)
flag – Video Mute
0 – Video enabled
1 – Video disabled
2 – Blank picture
Disable the video
output on OUT 2:
#VMUTE2,0<CR>
VMUTE?
Get video on output
status.
Video mute
parameter 2 (blank
picture) is not
supported.
COMMAND
#VMUTE?out_index<CR>
FEEDBACK
~nn@VMUTEout_index,flag<CR><LF>
out_index – Number that indicates the
specific output:
1-N (N= the total number of outputs)
flag – Video Mute
0 – Video enabled
1 – Video disabled
2 – Blank picture
Get video on output
status:
#VMUTE?2<CR>