Kramer VS-44H2

Kramer Electronics Ltd.
VS-44H2 – Using Embedded Webpages
19
3. Set the timeout in seconds for delaying:
▪ Switching upon signal loss when 5V power is left on.
▪ Switching when a new signal is detected.
▪ Switching in case a cable is unplugged.
▪ 5V power off when the signal is lost.
▪ Switching to the last video input signal after the manual override video input signal is
lost.
See table below for more detailed information.
4. Click Close.
Video timeouts are set.
The following table defines the timeout values and conditions:
Timeout
Description, Range (Default) and Conditions
Signal Loss
Description:
When the signal is lost, leave 5V power on and delay
switching for x seconds.
Range (default):
5 to 90 seconds (10 by default).
Conditions:
Signal Loss timeout ≥ 5 seconds.
Signal Loss timeout < Output Inactivity.
Signal Loss timeout < manual-override mode inactivity.
Signal Gain
Description:
When a new signal is detected, delay switching for x
seconds.
Range (default)
0 to 90 seconds (0 by default).
Conditions
No conditions.
Input Unplug
Description:
When the cable is unplugged, delay switching for x
seconds.
Range (default)
0 to 90 seconds (0 by default).
Conditions
Input Unplug timeout ≤ Output inactivity.
Input unplug timeout ≤ manual-override mode inactivity.
Output Inactivity
Description:
When the signal is lost, delay 5V power off for x seconds.
Range (default)
5 to 60000 seconds (900 by default).
Conditions
Output Inactivity timeout > Input Unplug.
Manual-Override Mode Inactivity
Description:
When video is lost on a manual override action, delay
switching for x seconds.
Range (default)
5 to 90 seconds (10 by default).
Conditions
Manual-Override Mode Inactivity timeout ≥ Signal Loss.
Manual-Override Mode Inactivity timeout ≥ Input Unplug.