Kramer VS-44H2

Kramer Electronics Ltd.
VS-44H2 – Using Embedded Webpages
23
Defining HDMI Input Port Parameters
VS-44H2 enables setting any of the four input signal parameters via the embedded
webpages.
To set an input port:
1. In the Navigation pane, click Routing Settings. The Routing Settings page appears.
2. Click an HDMI input (for example, HDMI 1).
Figure 18: Routing Settings Page – HDMI Input Settings
3. perform the following actions, if required:
▪ Enter a port label.
▪ Check HDCP support.
▪ Check force RGB and/or Force 2LPCM.
4. Click Save.
The HDMI input parameters are set.