Kramer VS-44H2

Kramer Electronics Ltd.
VS-44H2 – Using Embedded Webpages
24
Defining HDMI Output Parameters
VS-44H2 enables setting each of the four output signal parameters via the embedded
webpages.
To set an output port:
1. In the Navigation pane, click Routing Settings. The Routing Settings page appears.
2. Click an HDMI output (for example, HDMI 1).
Figure 19: Routing Settings Page – HDMI Input Settings
3. Perform the following actions:
▪ Enter a port label.
▪ View the routing status.
▪ Set routing to audio only.
▪ Select a video pattern from the Video pattern drop-down box.
▪ Select the switching mode from the Auto Switching drop-down box (Manual routing,
Priority or Last Connected switching, see Setting Auto Switching Mode on page 25).
4. Click Save.
The HDMI output parameters are set.