3. Click Ok and add the password details.
Figure 39: Settings Page – Security Activation Message
4. Click Save. The following message appears:
Figure 40: Settings Page – Password Updated
5. Click OK.
Webpages are accessed using authentication.
Changing the Ethernet Settings
The Communication tab shows the device details, such as IP Address, Mask, MAC address
and so on, and enables changing them. You can perform the following actions:
• Changing Ethernet Settings when DHCP is OFF on page 37.
• Changing Ethernet Settings when DHCP is ON on page 38.
Changing Ethernet Settings when DHCP is OFF
By default, DHCP is set to OFF.
To define Ethernet parameters when DHCP is set to OFF:
1. In the Navigation pane, click Settings. The General tab in the Settings page appears
(see Figure 34).
To Next Page
Loading...
