2. Select the Communication tab:
Figure 41: Settings Page – Communication Tab
3. Set DHCP to OFF (If not in the default state).
4. Change any of the parameters (IP Address, Netmask and/or Gateway) as required.
5. Change the TCP port number, if required.
6. Click Save.
After changing the IP address, reload the webpage with the new IP address.
If DHCP is checked, reload the webpage with the new IP address (see below).
Ethernet settings are defined.
Changing Ethernet Settings when DHCP is ON
For proper settings and before changing to DHCP, consult your Network administrator.
To define Ethernet parameters when DHCP is set to ON:
1. In the Navigation pane, click Settings. The General tab in the Settings page appears
(see Figure 34).
2. Select the Communication tab (see Figure 41).
3. Take note of the Device Name (you will need it later).
4. Set DHCP to ON.
5. Click Save.
6. Type the device name in the address bar of your browser to reload the page.
You can read the new IP address from the Network Settings page.
Ethernet settings are defined.
To Next Page
Loading...
