VS-44H2 – Operating VS-44H2 Via Front Panel Buttons
2. Press an input button (or ALL).
The selected input and 7-segment display LEDs of the selected inputs flash.
3. Press a disconnected output button.
Default EDID is copied to the selected inputs.
Operating via Ethernet
You can connect to VS-44H2 via Ethernet using either of the following methods:
• Directly to the PC using a crossover cable (see Connecting Ethernet Port Directly to PC
on page 13).
• Via a network hub, switch, or router, using a straight-through cable (see Connecting
Ethernet Port via Network Hub on page 15).
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
Connecting Ethernet Port Directly to PC
You can connect the Ethernet port of VS-44H2 directly to the Ethernet port on your PC using a
crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying VS-44H2
with the factory configured default IP address.
After connecting VS-44H2 to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center.
2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and click Change
settings of this connection.
The Local Area Connection Properties window for the selected network adapter appears
as shown in Figure 6.
To Next Page
Loading...
