Figure 8: Internet Protocol Version 6 Properties Window
6. Select Use the following IP Address for static IP addressing and fill in the details as
shown in Figure 9.
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255
(excluding 192.168.1.39) that is provided by your IT department.
Figure 9: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
Connecting Ethernet Port via Network Hub or Switch
You can connect the Ethernet port of VS-44H2 to the Ethernet port on a network hub or using
a straight-through cable with RJ-45 connectors.
Configuring Ethernet Port
You can set the Ethernet parameters via the embedded webpages.
To Next Page
Loading...
