Kramer VS-44H2

Kramer Electronics Ltd.
VS-44H2 – Using Embedded Webpages
22
3. Hover over a port to view its OUT-IN switching status (HDMI 3 input is routed to HDMI 1
output):
Figure 16: Routing Settings Page – Viewing the Switching Status
Input 3 is routed to output 1.
In the same way, you can route all the port types in the matrix if connected by a routing
button.
Setting HDMI Output Signals
Use HDMI Output icons to determine the output signal type.
To Set an HDMI output signal:
1. In the Navigation pane, click Routing Settings. The Routing Settings page appears.
Figure 17: Port Settings – HDMI Output Port Icons
2. The HDMI Output icons enable performing the following actions:
▪ Enabling audio only mode ( ): only audio is routed through the output (a black
pattern screen is displayed and 5V cut off is disabled).
▪ Selecting a pattern to display on the output ( or if a pattern is selected).
If a pattern is selected on an output and an input is routed to that output, the
pattern is disabled, and the routed video signal appears on the output.
▪ Turning HDMI on or off ( or ).
▪ Muting or unmuting the audio signal ( or ).
Output signals are set.