Kramer VS-88H2A

Kramer Electronics Ltd.
VS-88H2A – Operating VS-88H2A via Front Panel Buttons
19
3. Press LOCK to save changes.
The LOCK button flashes until the changes are saved. The device exits the ARC mode
and returns to Video switching mode.
The ARC can be routed to any of the balanced audio outputs and to the HDMI inputs.
An HDMI audio output is routed to a balanced stereo audio output port.
To route an HDMI OUT ARC to a balanced stereo audio output port:
1. Press D-AUDIO and A-AUDIO simultaneously.
Both buttons illuminate and the device enters the ARC routing mode (for example, HDMI
OUT 1, 2, 3 and 4 are enabled).
On the front panel button:
• An illuminated output button means that the corresponding output port is ARC
enabled.
On the 7-segment display:
• “.” under an output number indicates that arc is enabled on the corresponding output
(outputs 1 to 4 in this example).
• “A” under an output number indicates that an analog audio input is routed to that
output.
• “d” under an output number indicates that the embedded audio is routed to that
output.
• “0” under an output number indicates that the audio output is muted.
2. Press an output button (for example OUT 3). The corresponding 7-segment display LED
flashes.
3. Press an output button (for example OUT 8) to select the balanced audio output routing
destination.
The flashing 7-segment display LED shows the selected output number and
ARC (for example, OUT 3) is routed to the selected balanced audio output (for example,
OUT 8).
An HDMI OUT ARC is routed to a balanced stereo audio output port.