Setting Inputs
To adjust input settings:
1. In the Navigation pane, click Switching. The Switching page appears.
2. Select the AFV tab. Verify that Inputs (and not Patterns) is selected.
3. Click . The input settings window appears:
Figure 18: Switching Page – Input 1 Settings Window
4. If required, type the label name in the Label text box and click .
5. Set HDCP HDCP 2.2, HDCP 1.4 or No HDCP.
6. Click ARC to set input to ARC mode or click Step-In to set input to step-in mode.
7. In ARC mode click the settings button ( ).
The input ARC Settings window appears:
Figure 19: Switching Page – Input ARC Settings Window
8. Select an ARC source for input 1: either from analog inputs IN 1 to IN 8, or from HDMI
outputs 1 to 8.
The selected port routes its audio signal to HDMI input 1.
To Next Page
Loading...
