VS-88H2A – Using Embedded Web Pages
4. If required, type the label name in the Label text box and click .
Figure 16: Switching Page – Changing the Output Label
5. Click switch speed dropdown box to set the switching speed (normal, fast or extra-fast).
6. Click to mute or to unmute the video signal.
7. To set the output to:
▪ AFV mode, click .
▪ Breakaway mode, click .
indicates that the device is in the auto-switch mode and AFV status cannot be altered.
Setting the AFV mode icons to AFV or Breakaway modes reflects the next switching step
and not the current status.
Output settings are adjusted.
Viewing and Adjusting Input Settings
View and adjust the settings for each VS-88H2A input.
Figure 17: Switching Page – Input Button
Each input button displays the:
▪ HDCP status – HDCP is enabled ( ) or disabled ( ).
▪ Input signal HDCP status – supports HDCP ( ) or does not support HDCP ( ).
▪ Input status – a source is connected ( ) or not connected ( ) to the input.
Input settings are adjusted.
To Next Page
Loading...
