Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 1-13
DM4 DL Data Logger
The DM4 DL’s Data Logger only saves measurement
readings and not instrument settings.
Printing the measurement report
A Attention:
• Please note that header data and statistic informa-
tion contained in the report printout relate to the
DM4’s current instrument settings and not those
stored.
• Each dialog probe is marked with an individual
internal number in order to increase documentation
reliability. Therefore please observe the following:
The information in the file header under PROBE
and PROBE ID relating to dialog probes is only
printed when the same probe, as used with mea-
surement value recording, is connected during the
printout. If the probe is changed during measure-
ment value recording within a file, then the probe is
changed then the fields already mentioned remain
empty as well.
Important notes on thickness testing with the DM4 Introduction
Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 1-13
DM4 DL Data Logger
The DM4 DL’s Data Logger only saves measurement
readings and not instrument settings.
Printing the measurement report
A Attention:
• Please note that header data and statistic informa-
tion contained in the report printout relate to the
DM4’s current instrument settings and not those
stored.
• Each dialog probe is marked with an individual
internal number in order to increase documentation
reliability. Therefore please observe the following:
The information in the file header under PROBE
and PROBE ID relating to dialog probes is only
printed when the same probe, as used with mea-
surement value recording, is connected during the
printout. If the probe is changed during measure-
ment value recording within a file, then the probe is
changed then the fields already mentioned remain
empty as well.
Important notes on thickness testing with the DM4 Introduction
To Next Page
Loading...
