Krautkramer DM4E - Inhibiting a Memory Location; Selecting a Memory Location

6-8 Issue 05, 01/01 Krautkramer DM4E / DM4 / DM4 DL
Operation of the Data Logger (DM4 DL only) Storing the measurement values
Inhibiting a memory location
You can inhibit a memory location and proceed to the
next location, for example when you are not able to
measure a particular point within a measurement se-
ries.
If needed, you can select the inhibited memory loca-
tion later in order to store a measurement value there.
The inhibited memory location is simply overwritten.
Operation:
You are in the mode THK, THK/SPEC or MIN and
have activated a file in which you wish to store your
values.
– Uncouple the probe.
– Press r.
As usual the memory location number will be briefly
displayed, e.g. L.003. Finally OBST (obstruct) will
appear.
The memory location is inhibited.
– Simply carry out your next measurement.
The DM4 DL automatically stores the next measure-
ment value into the next memory location.
Selecting a memory location
You can individually select memory locations at which
the next measurement value is to be stored if, for ex-
ample, you overwrite an inhibited measurement value.
Operation:
You are in the mode THK, THK/SPEC or MIN:
– Press y .
The active memory location number is displayed, e.g.
+L.003.
Whereby:
+L.NNN = memory location allocated
-L.NNN = memory location empty
6-8 Issue 05, 01/01 Krautkramer DM4E / DM4 / DM4 DL
Operation of the Data Logger (DM4 DL only) Storing the measurement values
Inhibiting a memory location
You can inhibit a memory location and proceed to the
next location, for example when you are not able to
measure a particular point within a measurement se-
ries.
If needed, you can select the inhibited memory loca-
tion later in order to store a measurement value there.
The inhibited memory location is simply overwritten.
Operation:
You are in the mode THK, THK/SPEC or MIN and
have activated a file in which you wish to store your
values.
– Uncouple the probe.
– Press r.
As usual the memory location number will be briefly
displayed, e.g. L.003. Finally OBST (obstruct) will
appear.
The memory location is inhibited.
– Simply carry out your next measurement.
The DM4 DL automatically stores the next measure-
ment value into the next memory location.
Selecting a memory location
You can individually select memory locations at which
the next measurement value is to be stored if, for ex-
ample, you overwrite an inhibited measurement value.
Operation:
You are in the mode THK, THK/SPEC or MIN:
– Press y .
The active memory location number is displayed, e.g.
+L.003.
Whereby:
+L.NNN = memory location allocated
-L.NNN = memory location empty