Krautkramer DM4E - Page 65

Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 6-7
Storing the measurement values Operation of the Data Logger (DM4 DL only)
After a value has been stored in the Data Logger the
s key remains inhibited until a new valid measure-
ment. Zero values are not stored.
A Attention:
Make certain that all measurement values are stored
with the same resolution so that no errors occur with
statistical data in the report printout.
If you store the measurement values after each other
L.FUL will appear after the last memory location has
been allocated. When this happens, select a new file
or delete the stored measurement values (refer to
Chapter 6.5, Page 6-11).
H Note:
L.FUL appears every time an attempt is made to
store a measurement value onto a memory location
which is already allocated. For selecting individual
memory locations, e.g. to see if empty locations are
available in the file, refer to Page 6-8.
Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 6-7
Storing the measurement values Operation of the Data Logger (DM4 DL only)
After a value has been stored in the Data Logger the
s key remains inhibited until a new valid measure-
ment. Zero values are not stored.
A Attention:
Make certain that all measurement values are stored
with the same resolution so that no errors occur with
statistical data in the report printout.
If you store the measurement values after each other
L.FUL will appear after the last memory location has
been allocated. When this happens, select a new file
or delete the stored measurement values (refer to
Chapter 6.5, Page 6-11).
H Note:
L.FUL appears every time an attempt is made to
store a measurement value onto a memory location
which is already allocated. For selecting individual
memory locations, e.g. to see if empty locations are
available in the file, refer to Page 6-8.