Krautkramer DM4E - 6.5 Deleting stored measurement values

Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 6-11
Deleting stored measurement values Operation of the Data Logger (DM4 DL only)
6.5 Deleting stored measurement
values
You can either delete individual measurement values,
complete files or the total memory. Free memory loca-
tions can be reallocated with new measurement val-
ues after deleting individual measurement values.
Deleting and replacing individual
measurement values
Operation:
– With f and d u select the required file and
press f again.
– Press y and d u in order to select the required
memory locations.
– Press y and then d u until the measurement
value you wish to delete is displayed.
– Press r.
A message appears briefly indicating deletion of the
measurement value (e.g. C.0.02) and then the indica-
tion for an empty memory location:
– Press y again in order to return to the measure-
ment mode.
The measurement value is deleted. The new measure-
ment value can now be filed into the empty memory
location.
Deleting a file
A Attention:
When you delete a file, the data is irretrievably lost.
Save your data beforehand on an external data carrier
(refer to Chapter 7.2 Transferring data to a PC).
Operation:
– With f and d u select the required file, e.g.
+F.001.
– Press r and keep it pressed for about 3 seconds.
Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 6-11
Deleting stored measurement values Operation of the Data Logger (DM4 DL only)
6.5 Deleting stored measurement
values
You can either delete individual measurement values,
complete files or the total memory. Free memory loca-
tions can be reallocated with new measurement val-
ues after deleting individual measurement values.
Deleting and replacing individual
measurement values
Operation:
– With f and d u select the required file and
press f again.
– Press y and d u in order to select the required
memory locations.
– Press y and then d u until the measurement
value you wish to delete is displayed.
– Press r.
A message appears briefly indicating deletion of the
measurement value (e.g. C.0.02) and then the indica-
tion for an empty memory location:
– Press y again in order to return to the measure-
ment mode.
The measurement value is deleted. The new measure-
ment value can now be filed into the empty memory
location.
Deleting a file
A Attention:
When you delete a file, the data is irretrievably lost.
Save your data beforehand on an external data carrier
(refer to Chapter 7.2 Transferring data to a PC).
Operation:
– With f and d u select the required file, e.g.
+F.001.
– Press r and keep it pressed for about 3 seconds.