Krautkramer DM4E - Switching the Alarm off Again; Difference Mode: DIF

Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 5-15
Additional functions in the DM4 and DM4 DL Operation
Switching the alarm off again
– Press m until SPEC is displayed.
– Press u or d until HI-L or LO-L is displayed.
– Press c.
– Switch the corresponding function to OFF using u
or d.
– Acknowledge with c.
The corresponding alarm limit is switched off.
Difference mode: DIF
In the Difference mode the measured thickness is
compared with an adjustable nominal value.
The difference is displayed.
Operation:
– Press m until SPEC is displayed.
– Press d or u until DIF appears.
– Press c.
The active setting appears (basic setting: OFF).
– Press d or u in order to switch on the Difference
mode.
– Press c.
You will see the active nominal value which is set.
– Set the required nominal value with d or u.
– Press c again.
– Press m until you are in the Standard mode again.
Krautkramer DM4E / DM4 / DM4 DL Issue 05, 01/01 5-15
Additional functions in the DM4 and DM4 DL Operation
Switching the alarm off again
– Press m until SPEC is displayed.
– Press u or d until HI-L or LO-L is displayed.
– Press c.
– Switch the corresponding function to OFF using u
or d.
– Acknowledge with c.
The corresponding alarm limit is switched off.
Difference mode: DIF
In the Difference mode the measured thickness is
compared with an adjustable nominal value.
The difference is displayed.
Operation:
– Press m until SPEC is displayed.
– Press d or u until DIF appears.
– Press c.
The active setting appears (basic setting: OFF).
– Press d or u in order to switch on the Difference
mode.
– Press c.
You will see the active nominal value which is set.
– Set the required nominal value with d or u.
– Press c again.
– Press m until you are in the Standard mode again.