Krone BiG X 600-3 - Menu 3-12 Automatic Calibration of Sensors at Lifting Unit

Info centre "EasyTouch"
302
8.6.12 Menu 3-12 Automatic calibration of sensors at lifting unit
Risk of injury due to unexpected movement of parts!
During the calibration process, there is a risk of injury for persons who stay in the area of lifting
gear, front attachment and discharge chute.
- Make certain no one remains in the swivel range or in the range of movement of lifting
gear, front attachment and discharge chute during the calibration process.
Calibration prerequisites:
– Diesel engine speed = idle speed
– Release switch "road/field" is set to road mode.
– Release switch "traction drive" is switched off.
– Release switch "maintenance" is switched off.
– Switch "quick-stop console" is not actuated = OFF
– Switch "quick-stop manual operation" is not actuated = OFF
– The header has been folded out
– The seat switch is actuated (the driver's seat is occupied)
– The pendulum frame is horizontal.
– The machine is on a level surface.
5 6
7 8
B C D
BX770219
5 6
7 8
B C D
BX770220
Fig. 231
Main menu 3 Maintenance is active.
• Using the incremental encoder, choose menu 3-12 Automatic calibration of lifting unit.
• Press the incremental encoder.
The display shows menu level Automatic calibration of lifting unit.
Alternatively, the lifting unit can be calibrated manually, see page 264.
• To start the calibration, press
D
.