Krone BiG X 600-3 - Adjusting the Chop Length

Operation
577
18.5.13 Adjusting the chop length
Two chop lengths can be saved on the multi-function lever.
These can be called up on the multi-function lever during operation.
Fig. 506
Save the chop length with the cross actuating lever
Item
Designation
Explanation
1
Memory key "M1"
Call up chop length 1 if the function is assigned to
the M1 key, see page 183.
2
Memory key "M2"
Call up chop length 2 if the function is assigned to
the M2 key, see page 183.
3
Cross actuating lever
Call up the chop length 1: move to position I.
Call up the chop length 2: move to position II.
4
Key cross actuating lever
Press to save the chop lengths in conjunction with
the cross actuating lever.