Krone BiG X 600-3 - Maintenance - Supply System; Feed Attachment; Remove the Feed Attachment with Front Attachment

Maintenance – supply system
657
24 Maintenance – supply system
24.1 Feed Attachment
24.1.1 Remove the feed attachment with front attachment
The intake can be removed with the front attachment mounted; it must be folded down in the
case of the 2-part EasyCollect.

NOTE
Install and remove the intake on a level surface with load bearing ground.
Sufficient space must be available at the side for manoeuvring the machine.
• Place the intake with front attachment on the ground
• Switch off the engine
Preparation
Fig. 580
• Ignition on Level I, do not start diesel engine and press red momentary switch and
blue momentary switch (2) simultaneously to depressurise the hydraulic lines of the
front attachment.
• Press both momentary switches for the pendulum frame and (1) simultaneously
to depressurise the hydraulic lines of the pendulum frame. This is necessary if a hydraulic
cylinder is mounted (EasyCollect)
• Shut down and secure the machine, see page 41.