Krone BiG X 600-3 - Metal Detection; Rockprotect (Option)

Operation
566
Switch on/reverse the intake/front attachment using manual operation
Prerequisites:
– The ignition is switched on.
– The release switch road/field is in the "field mode" setting.
– The release switch "maintenance" is switched off.
– The release switch "intake/header" is switched on.
– The release switch "traction drive" is switched off.
– The main coupling is switched on.
– The quick-stop switch console is not actuated.
– The quick-stop switch manual operation is not actuated.
– The actuator test in menu 4-1-1 must not be active.
Fig. 500
• Press and hold the key (1) to reverse the intake/front attachment.
18.5.5 Metal Detection
When metal detection is triggered, intake/header stop instantaneously.
• Acknowledge the error message.
• Stop the machine and reverse a short distance.
• Raise the header slightly.
• Reverse intake/header.
• Shut down and safeguard the machine, see page 41.
• Remove the metal. The position of the metal can be seen in the error message, see page
177.
18.5.6 RockProtect (Option)
If a large foreign object (e.g. rock) is detected in the intake, intake/header stop instantaneously.
• Reset the error message.
• Stop the machine and reverse a short distance.
• Raise the header slightly.
• Reverse intake/header.
• Shut down and safeguard the machine, see page 41.
• Remove the foreign object.