Operation
45
Pos: 19.4 /Übersc hriften/Übersc hriften 2/F-J/F unktion der Schal ter Bedieneinh eit @ 35\mod_1 25792260286 3_78.doc @ 33338 7
8.1 Function of the switches on the control unit
Pos: 19.5 /BA/Bedi enung /EasyC ut/Funktion der Schalter Bedien einheit mit QFB EC 7540/9140 @ 1 1\mod_12234 46903803_78.d oc @ 146462
1
4
2
3
EC800038
Fig. 18:
The control unit can be used to select various functions of the machine. The actual functions are
performed by the control units.
The following table explains the function of the individual switches.
Item Designation Function
1 Pilot lamp (red) Lit when the control unit is turned on.
2 Flip switch Middle: Control unit off
Top: Control unit (1) (red 1): raises or lowers both mowing units
from the transport position to the headland position and vice-
versa.
Bottom: lower rocker switch (3) is activated.
3
Rocker switch
(only active if
rocker switch 2
is pointing
down)
Left: Control unit (1) (red 1): raises or lowers the left mowing unit
from the working position to the headland position or vice-
versa Control unit (2) (red 2): raises or lowers the right
mowing unit from the working position to the headland
position or vice-versa
Middle: Control unit (1) (red 1): raises or lowers both mowing units
from the working position to the headland position or vice-
versa
right: With "cross conveyor" option
Control unit (1) (red 1): raises and lowers the left cross
conveyor. Control unit (2) (red 2): raises and lowers the right
cross conveyor.
4 Rotary
potentiometer
With "cross conveyor" option
The rotary potentiometer can be used to adjust the speed of the cross
conveyors.
clockwise = faster
anticlockwise = slower
Pos: 19.6 /BA/---- -Seitenumbruch--- --- @ 0\mod _1196175311 226_0.doc @ 416 5
To Next Page
Loading...
