Settings
56
Pos: 21.7 /Übersc hriften/Übersc hriften 2/U-Z/Üb erschnitt einstell en @ 79\mod_131 4875045910_ 78.doc @ 698 940
9.2 Adjust overcut
Pos: 21.8 /Abkürzu ngen /Abkürzu ngen sprach neutral/EasyCut/E asyCut 9140 Shi ft @ 79\mod_1 31487609362 1_0.doc @ 69 8993
(EasyCut 9140 Shift)
Pos: 21.9 /BA/Eins tellungen/Mä hwerke/Eas yCut/Überschnitt ei nstellen Ausführu ng Shift @ 79\m od_13148756 68288_78.doc @ 698968
Fig. 27
The overcut to the front mowing unit can be reduced or enlarged with the outrigger arms (2)
(right and left side of machine). The machine is preset to position (I) in the factory.
Pos.I = basic setting (max. mowing width).
Pos.II = increase overcut 6 cm (on each side).
Pos.III = increase overcut 12 cm (on each side).
Procedure:
• Connect machine properly to the tractor.
• Lower the machine into working position.
• Lift machine slightly with the tractor's rear hydraulics.
• PTO shaft drive and tractor engine OFF.
• Activate tractor parking brake.
• Remove the ignition key.
Warning! - Outrigger arm can slip out.
Danger of injury due to crushing.
Never pull the outrigger arm (2) out further than is required for the adjustment.
• Remove the bolt (1).
• Move the outrigger arm (2) to the required position only with suitable equipment (same
setting for right and left side of machine).
• Install the bolt (1) and secure in place.
Pos: 21.10 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
