Settings
60
Pos: 21.22 /Überschrif ten/Überschrif ten 2/A-E/Ein stellung der E ntlastungsfed ern @ 0\mod_11 96666659447_7 8.doc @ 10133
9.5 Adjusting the Compensation Springs
Pos: 21.23 /BA/Sic herheit/Gefahre nhinweise/Mä hwerke/Einst ellung an den E ntlastungsfedern EC 7540/9140 @ 36\mod_125896659 4894_78.doc @ 3 35742
DANGER! – Setting on the compensation springs
Effect: Danger to life or serious injuries
• The threaded spindles (2) of the compensation springs (1) must not be turned out further
than dimension X (see table).
• The nuts (3) must not be resting against the feeder rake (4) (make certain dimension a is
set to 3-5 mm).
Pos: 21.24 /BA/Ei nstellungen/M ähwerke/EasyCut /Bodendruck/B odendruck allg emeiner Text alle EC @ 0\mod_ 1196667271181_7 8.doc @ 10190
The ground pressure for the cutter bar is adjusted to local conditions by means of the
compensation springs. In order to protect the sward the load on the mowing spar must be
relieved so that it does not jump when mowing, yet does not leave any skid marks on the
ground.
Pos: 21.25 /BA/Ei nstellungen/M ähwerke/EasyCut /Bodendruck/B odendruck Zus atz EC 7540/9 140 @ 11\mod_1 22345393083 5_78.doc @ 146 679
The ground pressure can be adjusted through threaded spindles (2).
Pos: 21.26 /BA/Ei nstellungen/M ähwerke/EasyCut /Entlastungsfe der(n)/Entlastu ngsfeder Bild Ec7 540/9140/1 0000 @ 42\mod_ 12725416675 36_78.doc @ 37 9120
EC810015_4
1
2
1
2
EasyCut 7540 /
EasyCut 9140 Shift
EasyCut 10000 Shift
1
2
EasyCut 9140 CV / Collect
a
a
3
3
4
4
X
EasyCut 7540 80 mm
EasyCut 9140 Shift 80 mm
EasxCut 9410 CV 80 mm
EasyCut 9140 CV Collect 50 mm
EasyCut 10000 Shift 80 mm
Fig. 31
Pos: 21.27 /BA/Ei nstellungen/M ähwerke/EasyCut /Entlastungsfe der(n)/Einstellu ngE ntlastungsfe der Hinweis EC 7540/9140 @ 11\ mod_12234544 34944_78.doc @ 146725
Note - Setting on the compensation springs
Effect: equal ground pressure
• For the adjustment of the compensation springs, the disc mower must be moved into the
transport position.
• Always make sure that the tensioning lengths of the springs on the right-hand and left-
hand sides are equal.
Pos: 21.28 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65