Krone Swadro 1000 - PTO Shaft

Commissioning
27
Pos: 19.9.1 /Überschr iften/Überschr iften 2/F-J/Gelenkwel le @ 0\mod_119978187979 4_78.docx @ 34542 @ 2 @ 1
5.3 PTO shaft
Pos: 19.9.2 /Überschr iften/Überschr iften 3/K-O/Längenan passung @ 1\mod_12016876 32810_78.docx @ 53589 @ 3 @ 1
5.3.1 Length adjustment
Pos: 19.9.3 /BA/I nbetriebnahme/Ersti nbetriebnahme/Gele nkwelle/Schwader/ Längenanpassung Bild Sc hwader @ 2\mod_12023649029 91_78.docx @ 58848 @ @ 1
3
2
SW9070007
1
Fig. 5
Pos: 19.9.4 /BA/I nbetriebnahme/Ersti nbetriebnahme/Gele nkwelle/Schwader/ Längenanpassung_mi t Weitwinkel Text_Sc hwader @ 2\mod_1202365111491 _78.docx @ 58868 @ @ 1
The PTO shaft (1) length must be adjusted.
• Disassemble the PTO shaft.
• Install each half (1) and (2) on the tractor and machine side respectively.
(The wide-angle coupling must be installed onto the machine. Observe the marking on
the PTO shaft.)
• Position rotary rake in the shortest PTO shaft position setting. (Completely the three-point
frame inwards.)
• For additional operating instructions refer to the operating instructions of the PTO shaft
manufacturer.
Note
Check the swivel range and clearance of the PTO shaft! Damage can be caused if the tractor
or the machine touch the PTO shaft. (e.g. hitching device, hitching frame)
Pos: 19.10 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1