Krone Swadro 1000 - Adjusting the Sensors

Maintenance
83
Pos: 42.34 /Übersc hriften/Überschri ften 3/A-E/Einstell ung der Sensoren @ 0\mod_119996 2173428_78.doc x @ 37635 @ @ 1
11.10.1 Adjusting the Sensors
Pos: 42.35 /BA/W artung/Sensoren/Namursen sor d = 30 mm a= 5mm @ 0\mod_11999625201 00_78.docx @ 37673 @ @ 1
11.10.1.1 Namur sensor d = 30 mm
a
BPXC0172
2
1
3
Figure 53
The dimension between the encoder (2) and the sensor (1) must be "a" = 5 mm
.
Setting
• Loosen the nuts on either side of the sensor.
• Turn the nuts until dimension "a" = 5 mm
is reached.
• Tighten the nuts again.
Pos: 42.36 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1