Start-up
51
Pos: 23.27 /Übersc hriften/Überschri ften 2/F-J/Gelenkwel le montieren @ 2\mod_12023983 42788_78.docx @ 59253 @ 2 @ 1
7.5 Install the PTO shaft
Pos: 23.28 /BA/Sic herheit/Gelenkwelle/ Gefahr - Sich dr ehende Gelenkwelle_2 @ 0\mod_11997 81692950_78.doc x @ 34523 @ @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 23.29 /BA/Sic herheit/Gelenkwelle/ Gefahr - Antriebsdreh zahl 540 beachten @ 3\mod_1 205316518245_78.doc x @ 73595 @ @ 1
Danger! - Observe drive speed
Effect: Danger to life or serious injuries
• This machine is driven at a maximum PTO speed of 540 rpm.
Pos: 23.30 /BA/Inbetr iebnahme/Schwader /Anbau Gelenkwelle/ Anbau Gelenkwelle angehän gte Schwader Bild @ 2\mod_ 1202398077960_78.do cx @ 59233 @ @ 1
5
4
2
SW9070008
3
6
1
3
1
Figure 26
Pos: 23.31 /BA/Inbetr iebnahme/Schwader /Anbau Gelenkwelle/ Anbau Gelenkwelle angehän gte Schwader Text @ 37\ mod_1263463772393_78. docx @ 339645 @ @ 1
• Switch off the engine and remove the ignition key.
• Install the PTO shaft (1) on the machine side (wide angle on machine side).
• Rotate the PTO shaft support (2) upwards.
• Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin
is securely engaged.
• Secure the PTO shaft guard against turning with the retaining chain (3).
Pos: 23.32 /BA/Inbetr iebnahme/Schwader /Maschine anheben Unter lenkeranhängung @ 2\mo d_1203505446705_78.doc x @ 66344 @ @ 1
Lifting the machine
• Lift machine slightly.
• Rotate the parking supports (4) 90° downwards and with the support (5) in this position
lock it and secure with spring cotter spring.
Pos: 23.33 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
