Krone Swadro 1000 - Replacing Tines

Maintenance
80
Pos: 42.28 /BA/W artung/Schwader/Zinken / Zinkenarme/Zinken ta uschen (im Reparaturf all) @ 139\mod_1354699792 713_78.docx @ 1241518 @ @ 1
11.9 Replacing Tines
7
6
5
1
2
3
4
SWN1400036
8
9
Fig. 51
1) Hex bolt M12 x 110 -10.9 2) Detent edged washer SKB 12
3) Washer 13x35x8 4) Fastening clamp
5) Support 6) Washer 13x24x2.5
7) Locknut M12 8) Tines
9) Tine arm Adhesive (high-strength) (order no. 938 627
0)
• Remove all tines in front of the broken tine to remove the broken tine.
• Remove the broken tine.
Installing New Tine
• Slide fastening clamp onto the tine.
• Slide tine onto the tine arm.
• Guide hex bolt with detent edged washer and washer from below through the fastening
clamp and the tine arm.
• Apply adhesive (high-strength) on the threading overhang of the screw.
• Install support, washer and locknut, raise tine on the tine end and tighten nut with torque
(85 Nm).
Proceed as described above with all tines.
Pos: 42.29 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ 1 @ 1