12 SERVICE WORK ON THE CHASSIS 90
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 83)
K00351-10
Main work
– Shift gear to neutral.
– Push the chain upwards near the vertical rib of the swingarm and measure the chain
tension
.
Info
The upper chain section
must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
Chain tension 5 mm (0.2 in)
» If the chain tension does not meet the specification:
– Adjust the chain tension. ( p. 91)
Finishing work
– Remove the rear of the motorcycle from the lifting gear. ( p. 83)
To Next Page
Loading...
