TROUBLESHOOTING 20
97
402136-10
The malfunctions are indicated by malfunction indicator lamp
1
and by acoustic signals that sound at the same time.
Tip
As a first measure for all malfunctions, switch off the vehi-
cle using the On/Off button, wait one minute, and switch it
on again.
If a malfunction is not eliminated by the steps specified
here, or a blink code is not listed, an authorized KTM work-
shop will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Faults Possible cause Action
Blink code 11 Malfunction in the throttle grip – Check the throttle grip for damage.
Blink code 12 Malfunction in the throttle grip – Check the throttle grip for damage.
Blink code 14 Throttle grip actuated during
activation
– Do not operate the throttle grip during
activation.
Blink code 24 System temperature too high – Allow the vehicle to cool down, clean
the cooling surfaces.
Blink code 31 Malfunction during charging – Disconnect the battery charger from
the vehicle and mains connection, wait
1 minute, restart the charging process.
Blink code 33 System temperature too high – Allow the vehicle to cool down, clean
the cooling surfaces.
Blink code 34 System temperature too low – Park the vehicle in a warmer environ-
ment.
Blink code 41 Vehicle moved during activation – Do not move the vehicle during activa-
tion.
Blink code 42 Motor speed outside the per-
missible range
– Do not roll backward with the vehicle.
Blink code 43 System temperature too high –
Allow the vehicle to cool down, clean
the cooling surfaces.
Blink code 71 Malfunction during charging – Disconnect the battery charger from
the vehicle and mains connection, wait
1 minute, restart the charging process.
– Replace the charging cable.
Blink code 72 Malfunction during charging – Disconnect the battery charger from
the vehicle and mains connection, wait
1 minute, restart the charging process.
– Replace the charging cable.
Blink code 73 Malfunction during charging – Disconnect the battery charger from
the vehicle and mains connection, wait
1 minute, restart the charging process.
– Replace the charging cable.
Blink code 83 Transport mode activated – Deactivate transport mode.
To Next Page
Loading...
