EasyManua.ls Logo

Kuka KR 470-2 PA - Page 90

Kuka KR 470-2 PA
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
90 / 125 Issued: 16.03.2016 Version: MA KR 300 470-2 PA V5
KR 300-2 PA, KR 470-2 PA
Section 7 Handling and storage
7.1 Precautions for safe handling
7.2 Conditions for safe storage, including any incompatibilities
7.3 Specific end use(s)
No further relevant information available.
Section 8 Limitation and monitoring of exposure / Personal protective equipment
Additional information for the design of technical systems: No further informa-
tion, see (>>> "Section 7" Page 90).
8.1 Control parameters
8.2 Limitation and monitoring of exposure
Safety measures: Avoid exposure to heat and direct sunlight.
No special measures required.
Instructions relating to fire
and explosion protection:
The product forms flammable fumes when heated.
Storage
Requirements regarding
storage rooms and contain-
ers:
No special requirements.
Information on storage with
other products:
Keep separately from oxidizing agents.
Further specifications con-
cerning storage conditions:
Protect from dirt.
Storage class
Classification according to
German Ordinance on
Industrial Safety and Health
(BetrSichV):
-
Components with applica-
ble occupational exposure
limit values:
The product contains no relevant amounts of materials that are
subject to monitoring of limit values in the workplace.
Additional information: These values are based on the lists valid at the time of issue.
Personal protective equipment
General protective and
hygiene measures:
The usual precautions when handling chemicals must be
observed.
Respiratory protection: Not necessary if room is well-ventilated.
Hand protection: Oil-resistant gloves.
The glove material must be impermeable and resistant to the
product / substance / preparation.
Due to lack of testing, no recommendation can be provided as
to the glove material for the product / preparation / chemical
mixture.
The selection of the glove material must consider breakthrough
times, permeation rates and degradation.

Table of Contents

Related product manuals