91 / 125Issued: 16.03.2016 Version: MA KR 300 470-2 PA V5
10 Appendix
Section 9 Physical and chemical properties
9.1 Information on basic physical and chemical properties
General information
9.2 Other information
No further relevant information available.
Section 10 Stability and reactivity
Glove material: The selection of a suitable glove depends not only on the mate-
rial but also on further quality characteristics. These will vary
from manufacturer to manufacturer. Since the product is a prep-
aration composed of several substances, the resistance of
glove materials cannot be determined beforehand and must
therefore be tested before use.
Breakthrough time of the
glove material:
The precise breakthrough time must be obtained from the glove
manufacturer and observed.
Eye protection: Safety goggles recommended when pouring the product.
Personal protective equipment
Appearance:
Physical state
Color
Liquid
Green
Odor: Perceptible
Odor threshold: Not determined
pH value: Not determined
Change in state:
Melting point / range:
Not determined
Change in state:
Boiling point / range:
Not determined
Flash point: 260 °C (COC)
Ignition temperature: Not determined
Decomposition tempera-
ture:
Not determined
Risk of explosion: Not determined
Lower explosion limit: Not determined
Upper explosion limit: Not determined
Vapor pressure: Not determined
Density at 15 °C:
0.87 g/cm
3
Relative density: Not determined
Vapor density: Not determined
Evaporation rate: Not determined
Solubility / miscibility in
water:
Insoluble
Partition coefficient (n-octa-
nol/water):
Not determined
Viscosity:
Dynamic
Kinematic
Not determined
Not determined
To Next Page
Loading...
