Kurzweil Forte - The DSP Modulation (DSPMOD) Page; DSP Mod Page Parameters

Program Edit Mode
The DSP Modulation (DSPMOD) Page
7-43
The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read Algorithm Basics on page 7-34 and Common DSP
Control Parameters.
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which
displays the the current layer’s algorithm, and highlights the corresponding function-block
when you select parameters.
DSP Mod Page Parameters
Parameter Range of Values Default
Source 1 Control Source List Off
Depth (Depends on Function) 0
Source 2 Control Source List Off
Depth Control Control Source List Off
Minimum Depth (Depends on Function) 0
Maximum Depth (Depends on Function) 0
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted
in Common DSP Control Parameters, any adjustments made to the function-parameters on
the DSPMOD page are reected in the corresponding function-parameters on the DSPCTL
page. e right-hand side of the DSPCTL page is the subpage of the highlighted function-
parameter—on the subpage are the programmable parameters. To access the parameters on
the subpage, highlight the function-parameter you wish to edit, and then press the > button
to move the cursor into the subpage.