Kurzweil Forte - Output; COMMON Page; COMMON Page Parameters; Tempo

Multi Edit Mode
COMMON Page
11-30
Output
is parameter species the physical audio output pair for the corresponding Aux Chain’s
output. e settings A and B refer respectively to the A and B physical audio outputs of the
Forte. Setting Output to Auto uses the output pair specied in the program on the specied
Aux Eects channel.
COMMON Page
e COMMON page contains parameters that aect every zone in the current Multi.
Press the COMMON soft button to enter the COMMON page.
COMMON Page Parameters
Parameter Range Of Values Default Value
Tempo 20 to 400 BPM 120
Clock Source Internal, External Internal
KB3 Channel 1 to 16 1
Tempo
When Clock Source (see Clock Source on page 12-5) is set to Internal, the Tempo parameter
sets the Forte’s system tempo for this Multi. e Tempo parameter values are in units of
BPM (beats per minute). is controls the tempo of any tempo based eects.
You can also set the tempo using the Tap Tempo button (located on the front panel above the
Pitch Bend Wheel.) Tap the Tap Tempo button on beat for a measure or two at the desired
tempo to set a tempo. is also brings up the Tap Tempo page (see Tap Tempo Button on
page 3-7).