Kurzweil Forte - Change Multis; Bank Select; Prgchangemode

Global Mode
MIDI Page
12-15
Change Multis
e Change Multis parameter determines the exact timing of Multi changes when you
select a dierent Multi, either by a normal data entry method or via MIDI program change
commands.
Choose AllKeysUp to indicate that you want Multi changes to take place only when you’ve
released all currently held notes.
Choose Immediate to indicate that you want such changes to happen immediately when you
select the Multi.
Bank Select
e Bank Mode parameter determines the controller number with which MIDI Bank change
messages are received.
For MIDI Bank change messages, various manufacturers have chosen dierent MIDI
controller numbers. Most have chosen Ctl 0, Ctl 32, or both. You can set this parameter to
any of the following three controller IDs:
Ctl 0
MIDI Bank change messages are sent with controller number 0.
Ctl 32
MIDI Bank change messages are sent with controller number 32.
Ctl 0 / 32
MIDI Bank change messages are sent with both controller numbers 0 and 32.
PrgChangeMode
e Program Change Mode (ProgChangeMode) parameter determines the format of
program change messages received by the Forte.
Program Change Type For Use With
Extended
Bank changes and Program changes. A bank has 128
IDs. Note that our system will recognize 16 banks, from
0 to 15. (2048 IDs).
This is for connecting a PC2 or a generic MIDI device
as a controller device.
K2600
Bank changes and Program changes. A bank has 100
IDs. Our system will recognize in this case 21 banks,
from 0 to 20. For example, with MIDI out from a K2600
into the MIDI in of the Forte, if you scroll or enter a
number in the K2600, you will see the same numbers
in the K2600 and in the Forte if the programs exist.