Kurzweil Forte - Changing the MIDI Transmit Channel; Panic

Program Mode
Changing the MIDI Transmit Channel
6-18
Changing the MIDI Transmit Channel
e current MIDI Transmit channel is shown on the right side of the top line of the display.
Press the Channel / Zone Up or Down buttons to change the MIDI Transmit channel. A
dierent Program can be selected for each MIDI Channel. All channels can be triggered
simultaneously from an external MIDI sequencer or computer. e Aux FX Chains of the
Program on the currently selected MIDI Channel are used for Programs on all Channels.
Pressing both Channel / Zone Up and Down buttons at the same time will reset the current
MIDI Transmit channel to 1.
Panic
Pressing the Keypad & Enter buttons simultaneously deactivates all sounding notes and
resets controller values by sending an “All Notes O ” message and a “Reset All Controllers”
message on all 16 MIDI channels.