Kurzweil Forte - Param; Adjust; Source; Depth

The Effects Chain Editor
FXLFO+ page
8-4
Param
e Param parameter selects which parameter of the specied box’s eect will be modulated.
Adjust
e Adjust parameter sets a xed value for the specied parameter (Param) that is applied
before any modulation.
Source
e Source parameter determines the Control source that will modulate the parameter
(Param) in real-time. is can be any of the normal channel Control sources (sliders, mod
wheel, pedals, etc.) or one of the Chain-specic Control sources (FXLFOs, FXASRs, and
FXFUNs).
Depth
e Depth parameter determines the range of modulation that the Controller will apply.
When the Control source has a value of 0, the parameter’s (Param’s) value will be the Adjust
value. When the control source is all the way up, the parameter’s (Param’s) value will be the
Adjust value plus the Depth value.
FXLFO+ page
is is where you can edit the Eects-only Control sources. ese are Control sources that
can be used by the eects Mods in the current Chain. e parameters on these pages work
exactly like those of the corresponding Control sources in program mode (see The LFO+
Page on page 7-44).