Kurzweil Forte - Enter + Controller

Multi Edit Mode
Selecting Parameters
11-5
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Assign Symbol
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
Enter + Controller
In Multi Edit Mode on the Controls page, when the Controller parameter is selected,
holding the Enter button and moving a controller (a Slider, Switch button, Mod Wheel or
Pedal) will jump to selecting that controller in the current Zone. is allows you to quickly
select a controller.
In a Controller destination eld in Multi Edit Mode, Enter + Controller will assign the
Destination of the touched controller to the selected controller.
Using Enter + Controller in an OnValue or OValue eld or in an Entry Position or Exit
Value eld, will set the value of that controller to the eld value. For example if you want to
set an OnValue to a value of 100, you can hold Enter and move a controller to quickly set
OnValue to 100.
Enter + Key
In Multi Edit Mode, on the Overview page, with the Low Key Range or High Key Range
parameter selected, hold the Enter button and strike a key to set the Low Key or High Key.
is will also work on the Control page with a Switch selected, when Mode = Chord. e
value of the Key elds can be set using Enter + Key.