Kurzweil Forte - Power off Time; Audio Input; Out Pair B Mode

Global Mode
MAIN1 Page
12-5
Power Off Time
If the Auto Power O parameter is set to On, then the Forte will power o after the time
selected by the Power O Time parameter has elapsed. e Forte will display the following
warnings before powering o. Press a key or move any Forte control to dismiss the warning
message. After dismissing this message, the Forte will wait the selected amount of time before
showing this warning again.
Audio Input
If you have an MP3 audio player plugged into the Forte’s rear “Audio In” jack, setting this to
On will allow audio to be heard. is signal will be mixed with sounds normally generated
by the Forte.
Clock Source
With the Clock Source parameter set to Internal, Forte plays using its own Tempo. If you
wish to sync the Forte to the tempo of an external device, use the External setting.
Out Pair B Mode
e B Audio Outputs can either be used as a second set of stereo (auxiliary) outputs by
setting this parameter to “Normal” or they can be used to mirror the main A Audio Outputs
by setting this parameter to “Mirror Primary Outputs”. By default this parameter is set to
Normal.