Kurzweil Forte - Alpha Wheel & Previous (-) and Next (+) Value Buttons; Assign; Using Enter + Controller

Program Edit Mode
Selecting Parameters
7-3
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Value buttons to the right of the display below the Alpha
Wheel, to change the selected parameter value. Turning the Alpha Wheel counter-clockwise
or pressing the Previous button will select the previous value and turning the Alpha Wheel
clockwise or pressing the Next button will select the next value.
Assign
Assign is the secondary function of the Enter button. You can use the Assign function to
quickly select parameters or set values for parameters by holding the Enter button while
moving Forte controllers (Sliders, Switch buttons, Keys, Mod Wheel, and Pedals).
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Using Enter + Controller
Assign will function dierently depending upon whether a parameter or its control is
highlighted in the display.
Select any parameter in the Parameter column, hold the Enter button and move a controller
(a Slider, Switch button, Mod Wheel or Pedal). Doing this will jump to selecting the
parameter that is assigned to the moved controller (if a parameter is assigned to that
controller).
Select the Control column for any parameter, hold the Enter button and move a physical
controller (a Slider, Switch button, Mod Wheel or Pedal). Doing this will assign the selected
parameter to be controlled by the moved controller.
Assign symbol