Multi Edit Mode
Overview Page
5-3
Browse All Programs
Make sure the USER button is o, then use the ALPHA WHEEL to select a Program from
all of the available Programs.
Select a Program by Category
Make sure the KEYPAD button is o, then press one of the CATEGORY buttons to select
the rst Program of a category (or the current Category Default Program). e selected
CATEGORY button will turn on. Use the ALPHA WHEEL to select Programs from the
selected category.
Select a Previously Saved User Program
Press and turn on the USER button, then use the ALPHA WHEEL to browse only User
Programs. To return to browsing Factory and User Programs, press and turn o the USER
button.
Select a Program by ID Number
Press and turn on the KEYPAD button. e KEYPAD button allows you to use the numbers
labeled on the CATEGORY buttons to select Programs or Multis by ID number. Type an ID
number followed by pressing the ENTER button to select the associated Program.
LoKey / HiKey
e LoKey and HiKey parameters set the playable key range of each Zone by setting the
lowest and highest playable key of each Zone. Keys played within this range will trigger a
note for the selected Zone. (You can also set a range where playing keys will not trigger a
note, by setting LoKey to a higher key than HiKey).
A Value for the currently selected LoKey or HiKey parameter can be selected by holding
down the ENTER button and then playing the desired key on the keyboard. Values can
also be selected by using the ALPHA WHEEL, or by using the keypad function of the
CATEGORY buttons, followed by pressing the ENTER button.
To Next Page
Loading...
