Kurzweil PC4 SE - Page 92

Multi Edit Mode
Overview Page
5-4
Pan
e Pan parameter sets the panning (left/right stereo placement) of each Zone. Change
the panning of a Zone by using the ALPHA WHEEL, or use the keypad function of the
CATEGORY buttons to type a pan value (0-127) followed by pressing the ENTER button.
A value of 0 is full left, 64 is center, and 127 is full right. Other values will move the stereo
placement in between these positions.
A value of “None” can be selected by using the ALPHA WHEEL to scroll below 0. A value
of “None” will use the last pan value used by the Zone’s MIDI channel (a MIDI channel
from Program Mode or from the previously selected Multi).
Vol
e Vol parameter sets the volume of each Zone. Change the volume of a Zone by using the
ALPHA WHEEL, or use the keypad function of the CATEGORY buttons to type a volume
value (0-127) followed by pressing the ENTER button.
A value of “None” can be selected by using the ALPHA WHEEL to scroll below 0. is is
useful if you wish to manually set Zone volumes with the PC4 SE knobs, rather than using
default values when the Multi is selected. A value of “None” will use the last volume value
used by the Zone’s MIDI channel (a MIDI channel from the previously selected Multi, or
from Program Mode).