If you have a GPS connected to the GyroTrac, no further action is
required. If you do not have a GPS connected to the GyroTrac,
KVH recommends that you complete the following steps to
speed satellite acquisition and improve system performance:
8. Type
HALT<cr> while the system is performing
the limit switch initialization routine. The system
will complete the initialization function by finding
the azimuth and elevation switch limits and then
go to the home position.
9. Determine your vessel’s current latitude and
longitude to the nearest degree.
10. Type
GPS,AA,B,CCC,D<cr> where
• AA = Latitude in degrees
• B = N (North) or S (South)
• CCC = Longitude in degrees
• D = E (East) or W (West)
11. Verify that the response shows the correct
parameters.
12. Type
ZAP to restart/reinitialize the system.
54-0161
114
TracVision G6 Technical Manual
To Next Page
Loading...
Need help?
General
