KYMCO Mongoose/KXR 250 User Manual

9.DRIVE AND DRIVEN PULLEYS
9-10
Mongoose/KXR 250
Check the movable driven face for wear or
damage.
Measure the movable driven face I.D.
Service Limit: 40.06mm replace if over
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the
driven pulley face.
Remove the snap ring and drive the outer
bearing out of the driven face.
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Bearing Puller E008
Seat the snap ring in its groove.
Apply grease to the driven face bore areas.
Press a new needle bearing into the driven
face.
Oil Seal And Bearing Install E014
Inner Bearing
Outer Bearing
Discard the removed bearing and replace
with a new one.
＊
Special
Pack all bearing cavities with proper
grease.
Specified grease: Heat resistance 230°C
＊
Special
Discard the removed bearing and replace
with a new one.
＊

KYMCO Mongoose/KXR 250 Specifications

General

Brand	KYMCO
Model	Mongoose/KXR 250
Category	Offroad Vehicle
Language	English