Configuration
1-97
5
Press the ENTER key. A question mark (?) appears.
6
Press the ENTER key. The toner counter is reset. The message
display returns to Ready.
Message Language
You can select the language of the messages on the message display by
following the procedure given below. You can optionally download messages
in order language. Contact your Kyocera Mita dealer for information.
1
Press the MENU key.
2
Press the or key repeatedly until Others > appears.
3
Press the > key.
4
Press the or key repeatedly until >MSG Language appears. The
default message language is English.
5
To change the language, press the ENTER key. A blinking question
mark (?) appears.
>New Toner
Installed ?
Others >
>MSG Language
English
>MSG Language
? English
To Next Page
Loading...
