Pagination
1-49
Code Set
You can change the character code set. Available character code sets vary
depending on the current font. (The default is IBM PC-8.)
1
Press the MENU key.
2
Press the or key repeatedly until Font > appears.
3
Press the > key. Press the or key until > Code Set appears.
4
Press the ENTER key. A blinking question mark (?) appears.
5
Press the or key until the desired character code set appears.
6
Press the ENTER key.
7
Press the MENU key. The message display returns to Ready.
Font >
>Code Set
IBM PC-8
>Code Set
?IBM PC-8
To Next Page
Loading...
