Operating the Storage Device
1-82
3
The default setting is Off. Press the ENTER key. A blinking question
mark (?) appears. Select On using the or key, and then press the
ENTER key.
4
Press the > key to display >RAM Disk Size.
5
Press the ENTER key again, and change the RAM disk size using the
or key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from 0001 to 1024 depending on the available printer memory.
6
When the desired RAM disk size is displayed, press the ENTER key.
7
Press the MENU key and restart the printer. The setting will be
activated after restart.
RAM Disk Mode
? On
>RAM Disk Size
0087 Mbyte
To Next Page
Loading...
