Interface
1-80
8
Press the > key. Each time the or key is pressed, the item
changes as shown below.
9
Display the item to be set and press the ENTER key.
For DHCP, a question mark (?) appears. For IP Address, Subnet
Mask, and Gateway, the cursor (
) blinks.
10
For DHCP, select On or Off using the or key. For IP Address,
Subnet Mask, and Gateway addresses, press the or key to
change the number (000 to 255) where the cursor is blinking. You
can use the > and < key to move the cursor right and left.
To obtain these addresses, consult your network administrator.
11
Press the ENTER key.
12
Press the MENU key. The message display returns to Ready.
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
To Next Page
Loading...
Need help?
General