Installing Option Units
A-23
2
Pull out the sub-tray that matches the size of the envelopes.
3
Load envelopes into the envelope feeder so that they feed in face up,
right edge first. Then adjust the envelope feeder’s paper guides to the
width of the envelope.
• Do not set different types of envelopes into the feeder at the same
time.
• Do not load envelopes into the envelope feeder higher than the
limitation marks ( ) on either side of the feeder.
• Do not force paper into the envelope feeder. Damage to the
mechanism may result.
Sub-tray
Paper Guides
Note
To Next Page
Loading...
Need help?
General