Kyocera ECOSYS M2535dn - Adjusting Density

3-8
Basic Operation
6 Remove the finished copies from the inner tray.
Adjusting Density
Use this procedure to adjust the density when copying.
The procedure for adjusting the density of copies is explained below.
1 Press the Function Menu key. Function Menu appears.
2 Press the  or  key to select [Density].
3 Press the OK key. Density appears.
4 Press the  or  key to select your desired density.
5 Press the OK key.
Completed. is displayed and the screen returns to the
basic screen.
6 Press the Start key. Copying begins.
Function Menu: a b
*********************
2 Collate T
3
Duplex T
[ Exit ]
1 Paper Selection T
Density: a b
4 w Lighter -1
*********************
6 z Darker +1
5 y Normal 0